PRODUCTS CENTER
Papua New Guinea Air Purification Device with Insertable Photocatalytic Technology for Air Conditioning Ducts
Category:
Product Description
Disinfection technology that kills bacteria and viruses
Energy-efficient design with low power consumption
Quiet operation, human-centered design, easy to operate and install.
Meets the requirement for 6 air changes.
Air Purification Principle
Technical Parameters
| Product Model | LD-4GUV-72 |
| Ultraviolet lamp | 4 18W ozone-free UV lamps (Diameter ø19mm, length 356mm) |
| Power (W) | 72 |
| Handling air volume | 8000 m3/h |
| Radiation intensity | AC 220V / 50Hz |
| Product dimensions | 340*230*414mm |
| Opening size | ø 110mm |
| Light source lifespan | 8,000 to 12,000 hours |
| Communication method | Can be remotely controlled via 485 communication. |
Product Dimension Diagram Unit (mm)
Installation Method
- As shown in the figure, make an opening in the pipe wall where the plug-in air disinfection device needs to be installed. Insert the device into the pipe in the direction indicated in the figure.
As shown in the figure, align with the pre-drilled holes and secure the device using M3 or M4 self-tapping screws.
- Operating temperature: 5℃~50℃
- Relative humidity around: ≤ 93%
- This product is a complementary device and is non-powered. It is suitable for installation in the return air, fresh air, and intermediate sections of ventilation systems, but is not appropriate for installation in environments with potential explosion hazards.
- Select the installation location: (Refer to the actual product for specifics.) The device is to be installed in the air conditioning and ventilation system. Choose a location that is easy to install and convenient for maintenance. Based on the device’s insertion length into the duct (347 mm), you’ll need approximately 500 mm of clearance width. The device must be recessed into the wall, so the wall must be pre-equipped with an opening of the appropriate size (ø110 mm).
RS486 Communication Control
